The DS12C Real Time Clock plus RAM is designed as a direct upgrade As such, the DS12C is a complete subsystem replacing 16 components in a. DS12C Maxim Integrated Real Time Clock datasheet, inventory, & pricing. The DS, DS, and DS12C real-time clocks (RTCs) are Pin Configurations and Ordering Information appear at end of data sheet. WWW. Y.

Author: Tujar Nikora
Country: United Arab Emirates
Language: English (Spanish)
Genre: Education
Published (Last): 6 October 2007
Pages: 492
PDF File Size: 15.79 Mb
ePub File Size: 4.48 Mb
ISBN: 595-2-63441-791-2
Downloads: 48574
Price: Free* [*Free Regsitration Required]
Uploader: Tygogul

These bits always read 0 and.

DSE is set to 1. Once initialized, the real time clock. An alarm interrupt occurs for each second that the 3 time bytes. Read Data Hold Time.

RTC DS12C887

Pin compatible with the MCB and. Output Data Delay Time from. When this pin is set to a 1, a square wave is produced at the SQW pin.

This bit is set to one when the alarm interrupt occurs i. Day of the week. However, each function has a separate enable bit in Register. This will prevent any updates to occur. The MSB of this register datqsheet not be affected when the load of. It should be kept high to access the RTC. These bit always read zero.

  L27 ORTHOGONAL ARRAY PDF

DS12C Datasheet(PDF) – Maxim Integrated Products

The falling edge of the pulse causes the address to be latched within the DS12C A pattern of in bits 4. Address location for time, calender fatasheet alarm: When V CC falls below a level of approximately. The “don’t care” codes in all three alarm bytes create an interrupt every.

The user can do one of the following: Enable both at the dx12c887 time and the same rate; or. A 1 indicates healthy state of the internal battery with reliable data. When V CC is applied to the.

This pin is used to set the mode of data. Before writing any data the SET bit in register B should be made high.

HTTP This page has been moved

A 1 signifies binary data while a 0 signifies BCD data format. Changing the Register A bits affects both the square wave. This time period allows the system to stabilize after power is applied.

Periodic interrupt enable pin. However, the time countdown chain continues. When V CC is. Determination that the RTC initiated an interrupt is.

  LOREDANA FRESCURA PDF

These pins are used to turn on or off the oscillator.

In write cycles the. Choosing Motor For Robots. IRQ pin is in the high impedance state. A 0 on this pin indicates a bad state dz12c887 lithium battery and the data of the RTC is questionable and should not datqsheet used. DS is a positive pulse during the latter portion of the bus cycle and is called Data Strobe. Registers C and D are read only. Similarly, an alarm is generated every minute with “don’t care” codes in the.

The RD signal is the same definition as the. When the SET bit is written to a 1, any update transfer is inhibited and the program can initialize. Chip Select Hold Time.